XT60 Pixhawk PRO Power Module

Description

Description

Presenting APM/Pixhawk Power Module Output BEC 3A XT60 Connector 28V 90A. A battery Eliminator circuit is a type of voltage regulator.it is used to prevent high voltage towards the Escs and pass the required voltage which is essential. As modern RC airplanes use high voltage batteries, it allows you to run your receiver, servos, and other accessories from your main battery without using a separate lower voltage one.

TheAPM 2.5.2/2.6/2.8Pixhawk Power Module is a simple way of providing yourAPM 2.5with clean power from a LiPo battery as well as current consumption and battery voltage measurements, all through a6-poscable. The on-board switching regulator outputs5.3Vand a maximum of2.25Afrom a2S-6S LiPo battery.The Power Module comes completely assembled with Deans or T connectors, and wrapped in shrink tubing for protection. Also, the circuit detects a sensing current around90 A.

Note : Actual product may vary in terms of version printed on it.

Note:The Power Module is only designed to power APM, an RC receiver, and APM accessories (GPS, 3DR radio). It is not designed to power the servos, please use your aircrafts own ESC/BEC for it

Specifications

• Input Voltage: 2S-12S

• PCB Cont.Current Rating: 60A

• PCB BurstCurrent Rating: 100A (<60 Sec)

• Max Current Sensing: 120A

• Output: DC 5.2V& 3A Max

• Voltage Divider: 18.182

• Amperes per Volt: 36.364

• Weight: 20g