Description
Vanquish Products M4 Machined Straight Rod Ends (Silver) (4)
Includes:
- (4) Machined Rod Ends
- (4) Brass Tension Set Pieces
- (4) M2.5 set screws (0.05in driver required)
- (4) Pivot Balls
- (1) Instructions
Assembly Notes:
- Due to differences in assembly between a molded rod end and a machined rod end, these rod ends may not cinch down and may still rotate slightly when installed.
- A small amount of thread lock should be used on the M2.5 set screw, excessive application of threadlock may cause the screw to be difficult to remove.
- Thread lock is not needed on the M(4) threads for the installation onto the link.
- Due to the nature of the small components patience is required during assembly. Careful inspection of orientation of components will allow easy setup upon initial assembly.
- Not for use on links with reverse cut threads (IE SCX10 III & Capra)
- Not recommended for extreme triangulated setups.
Reviews
There are no reviews yet.